Replace part on rear bumper?
  • OK, so we reversed into a low bollard and have scraped up the rounded sticking out bit of the rear bumper.  It looks as if it is separate to the main rear side but would it be a needle in a haystack job to try and source another? Does it detach easily or at all? Or should I get it touched up?

    Before and after photos attached
    IMG_3944 cropped.jpg
    976 x 1936 - 265K
    IMG_20161203_134402 small.jpg
    500 x 888 - 107K
  • I just touch up as it is low down on the bumper
  • If it's deeper than a touch-up and you want it perfect, you could just sand it back and get it re-sprayed. Shouldn't cost too much to do really.
  • Touch up is a practical solution since that part is not too noticeable.